Characterization of micro-holes drilled in alumina ceramic by the combined pulse laser technique.

Abstract

Nowadays, combined pulse laser (CPL) technology has shown obvious advantages in alumina ceramic drilling. However, the characterization of micro-holes drilled by the CPL is not clear. In this paper, micro-holes drilled by ns-ms and ns/ms CPLs are systematically compared from the aspects of hole diameter, cracks, spatter deposition, recast layer, re-solidified particles, grain size, and chemical composition. The results show that due to the synchronous output of the nanosecond laser, the ns/ms CPL can eject more melt through expelling of the plasma shock wave; thus, the recast layer, re-solidified particles, and oxygen vacancies are decreased, while the spatter deposition is increased. On the other hand, due to the higher temperature and larger temperature gradient introduced by the nanosecond laser, the hole diameter, cracks, and grain size are increased. Therefore, an ideal CPL method to optimize the drilling performance is proposed. The research results have important guidance for improving the processing quality of the CPL, especially for alumina ceramic laser processing.