Characterization of intermetallic Fe–Mn–Si powders produced by casting and mechanical ball milling

Abstract

Mechanical milling is a common method used to produce different powders. Milling time is one of the most important factors in the process, which affects characteristics such as particle size distribution and morphology. Four compositions of mechanically milled Fe–Mn–Si master alloy powders were investigated in the present paper. Milling times from 10 to 120 min were used. Particle size distribution and milling kinetics of Fe–Mn–Si powders were studied, and the parameters in breakage function have been determined. The results show that powder characteristics vary with the contents of silicon and manganese. During milling, the particle size initially decreases. At longer milling times, however, small particles agglomerate to larger particles (overmilling). The optimum milling time to get powders with very fine particle sizes is alloy-dependent. Apart from the agglomeration, the milling process of Fe–Mn–Si powders can be described by a classic batch-grinding equation based on the population balance model.