Abstract
Two biomimetic synthetic jet (SJ) actuators were designed, manufactured, and tested under conditions of a jet impingement onto a wall. Nozzles of the actuators were formed by a flexible diaphragm rim, the working fluid was air, and the operating frequencies were chosen near the resonance at 65 Hz and 69 Hz. Four experimental methods were used: phase-locked visualization of the oscillating nozzle lips, jet momentum flux measurement using a precision scale, hot-wire anemometry, and mass transfer measurement using the naphthalene sublimation technique. The results demonstrated possibilities of the proposed actuators to cause a desired heat/mass transfer distribution on the exposed wall. It was concluded that the heat/mass transfer rate was commensurable with a conventional continuous impinging jets (IJs) at the same Reynolds numbers.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
