Characterization of hydrogenated niobium interlayer and its application in TiAl/Ti2AlNb diffusion bonding

Abstract

Hydrogenation of niobium foil was achieved by cathodic charging and its application as the interlayer facilitates a sound joint of TiAl/Ti2AlNb. The microstructure and mechanical properties of hydrogenated niobium were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), nano-indentation and thermogravimetry (TG) analysis. It is demonstrated that the plasticity of the surface of niobium interlayer is improved and dislocation density in niobium crystal lattice increases significantly, owing to the process of niobium interlayer hydrogenation and subsequent dehydrogenation. To investigate the effect of the hydrogenation of the niobium interlayer on the TiAl/Ti2AlNb diffusion bonding joint, the pure niobium foil was also applied as the interlayer for comparison. The effect of the bonding parameters on the interfacial microstructure evolution and mechanical properties of the joints were systematically analyzed by SEM coupled with an energy-dispersive spectroscopy (EDS) and shear test. The typical microstructure of the joint is found to be TiAl/B2 phase/Nb/δ phase/β phase/Ti2AlNb. With the increase of the hydrogen content, bonding temperature, holding time and bonding pressure, the bonding defects decreased and the thickness of the diffusion layer increased correspondingly. The shear strength of joint reached 258.9 MPa at 950 °C for 40 min under a pressure of 5 MPa with the hydrogenated niobium interlayer of 1.0 wt% hydrogen content.