Characterization of Carbide Precipitation in Low-Carbon Martensitic Steels Using an Ultrawide Field-of-View 3D Atom Probe.

Abstract

It is important to understand the carbide distribution around high-energy sites such as dislocations and grain boundaries in martensitic steels as they have a major influence on the alloy performance. The aim of this study is to characterize fine ε carbides precipitated in low-carbon lath martensitic steel using the ultrawide field-of-view (FoV) CAMECA Invizo 6000 atom probe. We demonstrate the advantages of the wide FoV and determine the optimum conditions for analysis, by comparing the results such as the background noise and the C++/C+ charge state ratio (CSR) between voltage-pulsed and laser-pulsed modes. Increasing the laser pulse energy decreased the background noise and the CSR, where 70 pJ laser pulse energy produced a comparable mass-to-charge ratio spectrum to that recorded in voltage-pulsed mode, with the bulk compositions of C, Si, and Mn closest to that measured using voltage-pulsed mode. Increasing laser pulse energies to above 300 pJ decreased the bulk carbon content, with a more diffuse distribution of carbon around the carbides. This paper outlines some of the important experimental considerations when performing quantitative study of carbide precipitation in low-carbon martensitic steels using the Invizo 6000, considerations that can also be applied to other ferrous and non-ferrous alloy systems.