Abstract
AbstractThis study aimed to enhance the oxygen barrier properties of polylactic acid (PLA) film, a biodegradable packaging material with high oxygen permeability (OP). Bi‐layer films were produced by coating thermoplastic starch (TPS) onto PLA films in various ratios while maintaining constant film thickness. The mechanical, optical, barrier, thermal, hydrophobicity, moisture sorption, and microstructural properties of the films were analyzed. Increasing the TPS ratio elevated moisture content (MC), water uptake, solubility, and opacity while enhancing UV barrier properties. TPS coating reduced tensile and burst strength but increased the burst deformation of the bi‐layer films. Bi‐layer film production resulted in a water vapor permeability increase of 59.26%–94.44% compared with neat PLA while decreasing OP by 2.52%–29.66%. The equilibrium moisture content (EMC) rose with higher TPS ratios, displaying type II isotherms. FTIR analysis indicated no chemical interactions between PLA and TPS. Increasing the TPS ratio decreased PLA crystallinity, supporting the mechanical and barrier properties of the bi‐layer films. Neat and bi‐layer films exhibited smooth, homogeneous surfaces, with a visible interface in the cross‐section of the bi‐layer films. In conclusion, TPS shows promise as an alternative to improve oxygen barrier properties in PLA films without adversely affecting other properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
