Characterization of aqueous micellar solutions of amphiphilic block copolymers of poly(acrylic acid) and polystyrene prepared via ATRP. Toward the control of the number of particles in emulsion polymerization

Abstract

A series of diblock, triblock and star-block copolymers composed of polystyrene and poly(acrylic acid) were synthesized by ATRP. The structure of the copolymers, the size of the blocks and the composition were varied, keeping however a short polystyrene block and a poly(acrylic acid) content larger than 60 mol% to allow solubility in alkaline water. Their micellization was studied by static and dynamic light scattering and the influence of their structural characteristics on the aggregation number, N agg, was examined at low salt concentration and alkaline pH. It was shown that micelles were in thermodynamic equilibrium and that N agg followed the power law N agg∼ N A −0.9 N S 2 (with N A, the total number of acrylic acid units in the copolymer and N S, the total number of styrene units), that is characteristic of amphiphile micelles formed from strongly segregated block copolymers. Moreover, N agg was independent of salt concentration in the investigated range. The same copolymers were previously used as stabilizers in emulsion polymerization [Macromolecules 34 (2001) 4439]. The final latex particle concentration, N p, was compared with N m, the initial micelle concentration. This enabled us to conclude that among the block copolymers studied, those with high acid content behaved like low molar mass surfactants. In contrast, those with low acid content formed stable micelles that could be directly nucleated to create latex particles, allowing a good control over N p.