Abstract
An all-solid-state thin-film battery with a full cell structure of has been fabricated. The structural and electrochemical properties of a thin-film battery fabricated by an in situ and an ex situ process were compared. In the in situ process, LiPON (lithium phosphorus oxynitride) electrolyte thin film was deposited on the thin film by radio frequency reactive sputtering at room temperature without breaking vacuum. After deposition of the amorphous LiPON, a thermal evaporator in a dry room grew Li metal film as an anode. According to the results of the ac impedance analysis after 500 discharge cycle tests, and of a thin-film battery fabricated by the ex situ process are over ten times higher than those of the thin-film battery fabricated by the in situ process. The thin-film battery fabricated by the ex situ process showed high capacity reduction because of the high and This result indicated that the cyclability of the thin-film battery strongly depends on the interfacial stability between the solid electrolyte and the cathode during intercalation and deintercalation of Li ions. Therefore, the in situ process holds promise for the high performance of all-solid-state thin-film batteries. © 2001 The Electrochemical Society. All rights reserved.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
