Abstract
Present work is focused on Horizontal centrifugal casting process, by which a wear resistant material with considerable strength can be designed. A material of heterogeneous microstructure designed in which a high volume fraction of hard particles is dispersed at the inner surface, where better wear properties are needed, and a gradually decreasing lower volume fraction of hard particles at the outer surface. By this, a better strength and ductility will be achieved at the desired surfaces. The present work is focused on the preparation of cylinder liners using centrifugal casting for Al-17wt%Si. These cylinder liners are characterized for Microstructure, Hardness, Tensile strength and Wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.