Abstract
In this paper, the results of full characterization of a micromachined-silicon thermal gas flow sensor will be presented. The sensor is composed of two series of thermocouples on the right and left side of a polysilicon resistor, used as heater. The resistor and the hot contacts of the thermocouples lie on a thick porous silicon layer, which assures local thermal isolation, while the thermopile cold contacts lie on bulk silicon. Gas flow is parallel to the surface of the sensor and perpendicular to the resistor, which is heated at constant temperature. The power of the heater is stabilized by an external circuit, which provides a feedback current to compensate changes in the resistance of the heater under flow. Characterization of the sensor both under static conditions and under flow of different gases will be presented. The sensor shows high sensitivity [of the order of 175 /spl times/ 10/sup -3/ mV/(m/s)/sup 1/2/ per thermocouple] and very rapid response, below 1 ms, which makes it appropriate for use both under laminar and under turbulent flows.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
