Abstract

Oscillations in fully annular systems coupled by azimuthal modes are often observed in gas turbine combustors but not well documented. One objective of the present study is to characterize this type of oscillation in a laboratory scale system, allowing detailed pressure measurements and high speed visualization of the flame motion. The experiment is designed to allow detailed investigations of this process at a stable limit cycle and for an extended period of time. Experiments reported in the present article are carried out in the MICCA facility which was used in our previous work to analyze instabilities arising when the chamber backplane was equipped with multiple swirling injectors (Bourgouin et al., 2013, “Self-Sustained Instabilities in an Annular Combustor Coupled by Azimuthal Acoustic Modes,” ASME Paper No. GT2013-95010). In the present study, these units are replaced by a set of matrix injectors. The annular plenum feeds 16 such devices confined by two cylindrical quartz tubes open to the atmosphere. The multiple flames formed by the matrix injectors are laminar and have a well documented describing function. This constitutes an ideal configuration allowing systematic investigations of thermo-acoustic oscillations coupled by longitudinal or azimuthal modes while avoiding complexities inherent to swirling turbulent flames studied previously. Optical access to the chamber allows high speed imaging of light emission from the flames providing instantaneous flame patterns and indications on the heat release rate fluctuations. Eight waveguide microphones record the pressure signal at the combustor injection plane and in the plenum. Among the unstable modes observed in this setup, this analysis focuses on situations where the system features a spinning azimuthal mode. This mode is observed at a frequency which is close to that associated with the 1A mode of the plenum. A theoretical analysis is then carried out to interpret the angular shift between the nodal lines in the plenum and chamber, and the measured flame describing function (FDF) is used to quantify this shift and determine the linear growth rate.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.