Abstract

Rice straw can adsorb Cd(II) from wastewater, and modification of rice straw may improve its adsorption efficiency. The rice straw powder (Sp) from the direct pulverization of rice straw was used as the control, the rice straw ash (Sa), biochar (Sa), and modified rice straw (Ms) were prepared by ashing, pyrolysis and citric acid modification, respectively, and all of them were examined as adsorbents for Cd(II) in this study. Batch adsorption experiments were adopted to systematically compare the adsorption capacities of rice straw materials prepared with different modification methods for Cd(II) from aqueous solution under different levels of initial Cd(II) concentration (0–800 mg·L−1), temperature (298, 308, and 318 K), contact time (0–1440 min), pH value (2–10), and ionic strength (0–0.6 mol·L−1). The results indicated that the modification method affected the adsorption of Cd(II) by changing the specific surface area (SSA), Si content, surface morphology, and O-containing functional group of rice straw. Compared with Sp, Ms held more surface O–H, aliphatic and aromatic groups, while Sa had more phenolic, C–O (or C–O–C), and Si–O groups, and Sb held more C–O (or C–O–C) and Si–O groups; besides, Sa, Sb, and Ms had larger SSA than Sp. Adsorption capacity of the four adsorbents for Cd(II) increased and gradually became saturated with the increase in the initial Cd(II) concentration (0–800 mg·L−1). The adsorption capacity of Cd(II) was significantly higher at 318 K than 298 K and 308 K, regardless of the adsorbent type. Sa had the largest SSA (192.38 m2·g−1) and the largest adsorption capacity for Cd(II). When the initial Cd2+ concentration was at 800 mg·L−1, the Cd(II) adsorption amount reached as high as 68.7 mg·g−1 with Sa at 318 K. However, the SSA of Sp was only 1.83 m2·g−1, and it had the least adsorption capacity for Cd(II). Only the adsorption of Cd(II) upon Sb at 298 K was spontaneous, and surprisingly, all other adsorptions were nonspontaneous. These adsorptions were all chemical, and were favorable, exothermic and order-increasing processes. The pseudo-second-order model showed a strong fit to the kinetics of Cd(II) adsorption by the four adsorbents. The adsorption capacities of Cd(II) by the adsorbents were less at low pH, and all were enhanced with the increase of initial pH value (2–10) in the solution. The inhibiting effect on Cd(II) adsorption due to the increase in ionic strength was greater with Sa, Sb, and Ms than that under Sp. The rice straw ash prepared by ashing unexpectedly had greater adsorption capacity for Cd(II) than the biochar and citric acid modified rice straw. The optimum condition for Cd(II) adsorption was established as the temperature of 318 K, initial Cd(II) concentration of 800 mg·L−1, contact time of 240 min, and no Na(I) interference regardless of absorbent. In conclusion, rice straw ash shows the greatest potential of being applied to paddy fields for the remediation of Cd(II) pollution so as to reduce the risk of Cd(II) enrichment in rice grains and straws.

Highlights

  • Cadmium (Cd) is considered one of the most toxic and hazardous heavy metals due to its high mobility and biological accumulation, and can cause a potential threat to human life with prolonged exposure[1,2,3]

  • The specific surface area (SSA) and pore volume results presented the same trend in our study, indicating that the microstructure and pore properties of rice straw benefited from the modification[27]

  • It was obvious that different modification methods exerted different effects on the surface morphology of rice straw, which might affect the removal of Cd(II) by rice straw from water

Read more

Summary

Introduction

Cadmium (Cd) is considered one of the most toxic and hazardous heavy metals due to its high mobility and biological accumulation, and can cause a potential threat to human life with prolonged exposure[1,2,3]. In order to separate and remove heavy metal pollutants from water bodies, several technologies, such as adsorption, ion exchange, membrane separation, coagulation/flocculation, reverse osmosis, electrodialysis, and chemical precipitation[2], have been developed in recent years. Out of these technologies, adsorption is considered the most promising method because of its high efficiency, low cost, simple operation, fast response, and environmental friendliness[1,8,9]. Feng et al.[21] observed that when rice husks were heated at a high temperature of 700 °C, their adsorption capacity for Pb(II) and Hg(II) from the aqueous solution was enhanced because of the increased specific surface area. Rice husk ash showed significant advantage over rice husks in the removal of Pb(II) from aqueous solution[22]

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call