Abstract

A three-dimensional (3D) printing pen is a popular writing instrument that uses a heated nozzle, and is similar to a 3D-printer. Processing thermoplastic filaments with a 3D-pen can emit ultrafine particles (UFPs). 3D-pen education sessions were held with "∏"-shaped partitions for the prevention of coronavirus disease (COVID-19). This study aimed to characterize UFP emissions from two types of 3D-pens and evaluate the influence of "∏"-shaped partitions on UFP exposure. Measurements of UFP emission rates and the size distribution of particles emitted from 3D-pens were conducted in a chamber (2.5m3 ). The partition's influence on UFP exposure was evaluated with and without a "∏"-shaped partition on a desk. A scanning mobility particle sizer (SMPS) and an optical particle spectrometer (OPS) were used to measure the particle number concentration (PNC) and size distribution. For both 3D-pen A and B, the average emission rates were statistically significantly highest for acrylonitrile butadiene styrene (ABS) filament (8.4×106 [3.4] particles/min and 1.1×106 [1.8] particles/min), followed by polylactic acid (PLA) (2.8×105 [1.5] particles/min and 4.8×104 [1.8] particles/min) and polycaprolactone (PCL) filaments (1.4×104 [2.8] particles/min and 2.0×104 [2.8] particles/min). For all filaments, particles in the Aitken mode (30-100nm) accounted for the highest proportion. In 3D-pen A, PNCs were higher with the partition than without it for ABS (1.2×106 [1.15] particles/cm3 vs. 1.4×105 [1.29] particles/cm3 ) and PLA (6.2×105 [1.38] particles/cm3 vs. 8.9×104 [1.12] particles/cm3 ), whereas for 3D-pen B, they were higher with the partition for ABS (9.6×105 [1.13] particles/cm3 vs. 4.9×105 [1.22] particles/cm3 ) only. With the partition installed, PNCs decreased to the background level after the operation ended, whereas it took 2-6min without the partition. However, the mass concentrations of PLA and PCL with 3D-pen A were not statistically significantly different with respect to the partition status. The use of 3D-pens with a partition can lead to high UFP exposure. Therefore, guidelines are required for the safe use of 3D-pens and partitions.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call