Characteristics of the wind drift layer and microscale breaking waves

Abstract

An experimental study, investigating the mean flow and turbulence in the wind drift layer formed beneath short wind waves was conducted. The degree to which these flows resemble the flows that occur in boundary layers adjacent to solid walls (i.e. wall-layers) was examined. Simultaneous DPIV (digital particle image velocimetry) and infrared imagery were used to investigate these near-surface flows at a fetch of 5.5 m and wind speeds from 4.5 to 11 m s−1. These conditions produced short steep waves with dominant wavelengths from 6 cm to 18 cm. The mean velocity profiles in the wind drift layer were found to be logarithmic and the flow was hydrodynamically smooth at all wind speeds. The rate of dissipation of turbulent kinetic energy was determined to be significantly greater in magnitude than would occur in a comparable wall-layer. Microscale breaking waves were detected using the DPIV data and the characteristics of breaking and non-breaking waves were compared. The percentage of microscale breaking waves increased abruptly from 11% to 80% as the wind speed increased from 4.5 to 7.4 m s−and then gradually increased to 90% as the wind speed increased to 11 m s−. At a depth of 1 mm, the rate of dissipation was 1.7 to 3.2 times greater beneath microscale breaking waves compared to non-breaking waves. In the crest–trough region beneath microscale breaking waves, 40% to 50% of the dissipation was associated with wave breaking. These results demonstrated that the enhanced near-surface turbulence in the wind drift layer was the result of microscale wave breaking. It was determined that the rate of dissipation of turbulent kinetic energy due to wave breaking is a function of depth, friction velocity, wave height and phase speed as proposed by Terrayet al. (1996). Vertical profiles of the rate of dissipation showed that beneath microscale breaking waves there were two distinct layers. Immediately beneath the surface, the dissipation decayed as ζ−0.7and below this in the second layer it decayed as ζ−2. The enhanced turbulence associated with microscale wave breaking was found to extend to a depth of approximately one significant wave height. The only similarity between the flows in these wind drift layers and wall-layers is that in both cases the mean velocity profiles are logarithmic. The fact that microscale breaking waves were responsible for 40%–50% of the near-surface turbulence supports the premise that microscale breaking waves play a significant role in enhancing the transfer of gas and heat across the air–sea interface.