Characteristics of the pyrolytic products and the pollutant emissions at different operating stages from a pilot waste tire pyrolysis furnace

Abstract

Pyrolysis is considered a highly practical, cost-effective, and environment-friendly technology for waste tires disposal. In this study, pyrolysis processes of waste tires were conducted in a pilot scale furnace feeding at 30 kg/h. The properties of pyrolytic products and the distribution patterns of pollutants generated in different operating stages (start-up, steady, and shut-down) were investigated. The pyrolytic gas in the steady state had a high caloric value of 10799 kJ/Nm3, valuable as heating source for pyrolysis. The elements of sulfur and zinc were effectively fixed as ZnS in the pyrolytic carbon. The basic properties of pyrolytic oil were in line with commercial diesel oil except for the lower flash point. Heavy metals were mainly concentrated in the pyrolytic carbon, with slightly higher concentrations in the steady state. Moreover, polycyclic aromatic hydrocarbons (PAHs) and polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) were mainly concentrated in the pyrolytic oil, with predominated low-ring PAHs and high chlorinated PCDD/Fs. The concentrations of PAHs and PCDD/Fs in the gas phase were higher during the start-up stage due to the memory effect, whereas were effectively reduced during the steady stage. The concentration of PAHs in the solid phase was highest during the furnace start-up and lowest in the shut-down stage. In contrast to PAHs, the PCDD/Fs in the solid phase reached their highest concentration during the shut-down stage, which was mainly affected by temperature. The results provide guidance for the reducing of pollutant emissions and the recycling of pyrolytic products.