Abstract
Alumina-based refractory materials are known to possess good chemical attack resistance at high temperatures; thus, they are often used as linings for furnaces and incinerators. However, there are still several components in such commercial alumina refractory materials which limit their corrosion/erosion resistance, e.g., material inhomogeneity (existence of aggregates) and porosity. These promote corrosion attack and allow corrosive agents to penetrate and can possibly increase erosion damage. These properties, although recognised, are very difficult to overcome by current refractory manufacturing practice. Laser surface treatment is one novel method that has potential for eliminating porosity and producing a homogeneous surface layer. This paper describes microstructural and morphological characteristics of CO 2 and diode laser-treated 60% and 85% alumina refractory materials using SEM and optical microscopy. The research shows that a denser, uniform surface layer with solidification microstructures and which resists thermal shock, can be produced. The use of a high power diode laser for surface treatment of refractory materials is reported for the first time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.