Characteristics of an extended internal fixation system for polysegmental transpedicular reduction and stabilization of the thoracic, lumbar, and lumbosacral spine.

Abstract

The Kluger internal fixator, with its artificial fulcrum outside the operative site, had to be extended for multisegmental use. Three different prototypes, called Central Bar (CB), Double Bar I (DB I) and Double Bar II (DB II) were designed, which were fully compatible with the existing reduction system. To evaluate the ability of these newly developed systems to provide primary stability in a destabilized spine, their stiffness characteristics and stabilizing effects were investigated in multidirectional biomechanical stability tests and compared with those of the clinically well-known Cotrel-Dubousset (CD) system. The investigations were performed on a spine tester using freshly prepared calf spines. The model tested was that of an intact straight spine followed by a defined three-column lesion simulating the most destabilizing type of injury. Pure moments of up to 7.5 Nm were continuously applied to the top of each specimen in flexion/extension, left/right axial rotation, and left/right lateral bending. Segmental motion was measured using a three-dimensional goniometric linkage system. Range of motion and stiffness within the neutral zone were calculated from obtained load-displacement curves. The DB II attained 112.5% (P = 0.26) of the absolute stiffness of the CD system in flexion and enhanced its stability in extension by up to 144.3% (P = 0.004). In axial rotation of the completely destabilized spine, this system achieved 183.3% of the stiffness of the CD system (P < 0.001), and in lateral bending no motion was measured in the most injured specimens stabilized by the DB II. The DB I, which was the first to be designed and was considered to provide high biomechanical stability, did not attain the stiffness standard set by the CD system in either flexion/extension or axial rotation of the most injured spine. The study confirms that it is worthwhile to evaluate in vitro the biomechanical properties of a newly developed implant before its use in patients, in order to refine weak construction points and help to reduce device-related complications and to better evaluate its efficacy in stabilizing the spine.