Abstract

Measured and predicted rotordynamic characteristics are presented for a 4-pad, spherical-seat, TPJB with 0.5 pivot offset, 0.6 L/D, 101.6 mm nominal diameter, and 0.3 preload in the load-between-pivots orientation. One bearing is tested four separate times in the following four different lubrication configurations: (1) flooded single-orifice (SO) at the bearing shell, (2) evacuated leading edge groove (LEG), (3) evacuated spray-bar blocker (SBB), and (4) evacuated spray-bar (SB). The same set of pads is used for every test to maintain clearance and preload; each method of lubrication is added as an assembly to the bearing. Test conditions include surface speeds and unit loads up to 85 m/s and 2.9 MPa respectively. Dynamic data includes four sets (one set for each bearing configuration) of direct and cross-coupled rotordynamic coefficients derived from measurements and fit to a frequency independent KCM model. The pivot stiffness (pad and pivot in series) is measured and incorporated into predictions.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.