Characterisation of HVOF sprayed Cr3C2-50(Ni20Cr) coating and the influence of binder properties on solid particle erosion behaviour

Abstract

Abstract The coating Cr 3 C 2 with 50 wt.% Ni20Cr deposited by high velocity oxy-fuel (HVOF) spray process was characterized in detail to investigate the effect of annealing on the solid particle erosion behaviour and understand the influence of the binder properties. Systematic characterization of the coating was carried out using electron microscopy (scanning electron microscopy (SEM), transmission electron microscopy (TEM) and electron probe microanalysis (EPMA)), X-ray diffraction (XRD), microindentation and nanoindentation techniques. The solid particle erosion tests were done on the as-sprayed coating and coatings annealed at 400 °C, 600 °C and 800 °C using silica erodent particles. The coefficient of restitution of the coated samples was also measured by WC ball impact tests to simulate dynamic impacts. The as-sprayed coating consisted of primary carbides and binder that was a mixture of amorphous and nanocrystalline phases. Annealing leads to recrystallisation of binder phase and precipitation of secondary carbides. The coating hardness and binder ductility change with annealing temperature. The erosion resistance improves with annealing up to 600 °C. In the as-sprayed coating, the amorphous phase, inter-splat boundaries and the elastic rebound characteristics affect the erosion response. While in the case of the coating annealed at 600 °C, the presence of ductile crystalline binder, fine carbide precipitates and embedment of erodent particles together improve solid particle erosion resistance.