Abstract
This chapter focuses on various welding methods in context to amorphous nylon. Welding methods, which can be considered, are heated tool welding, vibration and spin welding, and ultrasonic welding. The heating or welding times as well as the joining pressure are part dependent and must therefore be empirically determined. Trogamid moldings can in principle be subjected to all known welding processes. For sufficient weld seam strength, the achievement of a correspondingly high melt temperature in the joint area from about 260°C to 310°C is important. Owing to its amorphous nature and its melt toughness, the temperature range is not as critical as in the semicrystalline polyamides. The chapter informs that for good welding results in series manufacture, the observance of small dimensional tolerances in the joint area is very important.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
