Changes in the Peeled Surfaces of Copper Thin Films Deposited on Polyimide Substrates After Heat Treatment

Abstract

Peel strength between a copper (Cu) thin film and a polyimide (pyromellitic dianhydride-oxydianiline, or PMDA-ODA) substrate is reduced by heat treatment at 150°C in air. In this work, we investigated the peel strength, the morphology of the interface between Cu films and polyimide substrates using optical microscopy and electron microscopy, and chemical change of the interface using Auger electron spectroscopy (AES) and micro X-ray photoelectron spectroscopy (XPS). The analysis showed that CuO “lumps” were present on the peeled surface of PMDA-ODA after heat treatment at 150°C in air. The peeled surfaces of other polyimide substrates were also analyzed: biphenyl dianhydride-para phenylene diamine (BPDA-PDA) and biphenyl dianhydride-oxydianiline (BPDA-ODA). CuO lumps were present on the peeled surface of BPDA-ODA after the heat treatment, but not that of BPDA-PDA. Compared with the adhesion strength for the Cu thin film, the adhesion strength was high for the Cu/PMDA-ODA and Cu/BPDA-ODA laminates, but the adhesion strength was very low for the Cu/BPDA-PDA laminate. This low strength is the reason that CuO lumps were not detected on the peeled surface of the BPDA-PDA substrate. These CuO lumps were related to the adhesion degradation of the Cu/polyimide laminates after the heat treatment.