Abstract
It is well known that magmatic plumbing systems change over time, but there is much debate as to why and how. We studied volcanic ejecta continuously deposited in an outcrop at Kagosaka Pass at the eastern base of Mount Fuji to investigate the factors responsible for changes in the magmatic plumbing system. The sample consisted of pyroclastic sediments from explosive eruptions for approximately 3000 y, which sandwiched the time of the Gotemba sector collapse at approximately 2500 BP. Chemical analyses of whole rocks, minerals, and matrix glasses, as well as mode measurements of glass and bubbles, were performed on samples collected from approximately 30 layers; significant changes were observed before and after the collapse. For example, before and after the collapse, matrix glass area increased around 60% to over 80% and anorthite content (Ca / (Ca + Na) * 100) of phenocryst plagioclase decreased from over 80 to below 65. For a period after the collapse, possibly hundreds of years, the plagioclase and olivine phenocrysts exhibited characteristics indicative of crystallization at low temperatures and pressures, and the pyroclast matrix became highly vitreous. Eruptions with ejecta of these characteristics continued more than a dozen times, lasting about 500 years. In addition, the trend in the distribution of the bulk rock chemical composition changed significantly, showing a differentiation trend with only plagioclase and clinopyroxene crystal separation. An investigation using the MELTS software revealed that the phenomenon of direct eruptions from deep magma chambers to the surface, bypassing shallow magma reservoirs, continued for several hundred years after the collapse. This can be interpreted as a decrease in confining pressure associated with the collapse, facilitating the eruption of magma from the depths. Furthermore, based on an examination of the water content in the magma during this period, we posit that the trigger for the rise of magma from the deep magma chamber of Mount Fuji is the acquisition of excess pressure by the injection of magma from a deeper level.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.