Changes in Optical Characteristics and Surface Topography of CAD/CAM Materials after Bleaching Applications: An AFM Evaluation.

Abstract

To evaluate the effect of in-office and at-home bleaching agents on color changes (ΔE00 ), translucency (TP00 ), whiteness (WID ), surface roughness (Ra ), and surface topography (Rsk and Rku ) of a resin nano-ceramic and a polymer-infiltrated ceramic network CAD/CAM material. Sixty specimens (6 mm × 7 mm × 1.3 mm) were prepared from Lava Ultimate (LU) and Vita Enamic (VE). The specimens were divided into 6 groups according to the bleaching agents applied (n = 10/group): control, Perfect Bleach Office + (PBO), Opalescence Boost (OB), Perfect Bleach (PB) with 10% and 16% carbamide peroxide and Whiteness Perfect (WP). ΔE00 values were calculated before and after bleaching procedures with a spectrophotometer using the CIEDE2000 formula. ΔTP00 and ΔWID values were calculated for each material. Ra , Rsk , and Rku values of the specimens were evaluated with an Atomic Force Microscope. Two-way ANOVA was used for statistical analyses of the parameters measured after bleaching. For pairwise comparisons, Tukey test was performed. For LU, no statistically significant difference among the ΔE00 values of the groups was observed (p = 1.000). For VE, only WP group presented significantly higher values (2.12 ± 2.66) than the other groups (p < 0.001). For both materials; ΔTP00 values of at-home bleaching groups were significantly higher than in-office bleaching groups and control group (p < 0.001). For VE, ΔWID values did not demonstrate statistically significant difference (p = 1.000); however, for LU, PBO applied group showed statistically higher ΔWID values (3.00 ± 2.38) (p = 0.010) and WP applied group showed lower ΔWID values (0.47 ± 0.31) than the other groups (p = 0.030). For both LU and VE, there was no statistically significant difference among the groups regarding Ra (F = 4.544), Rsk (F = 2.369), and Rku values (F = 2.391) (p = 1.000). All of the VE groups presented Ra values higher than 0.2 µm. The optical properties of LU and VE after bleaching applications were affected by the contact time with bleaching agents rather than concentration. Bleaching procedure had no effect on the surface properties of these materials.