Abstract
AbstractThe Elastic Multi‐Body Simulation (EMBS) is the state‐of‐the‐art method when dealing with elastic deformations of components in complex mechanical systems. But the required FE‐model representing the elastic structure contains several uncertainties concerning geometry, local and directional stiffness as well as damping phenomena. A mandatory Model Order Reduction (MOR) embodies further approximation errors. Due to the drawbacks of the conventional procedure, a novel approach is suggested, where the data of the elastic body model is directly gained from the results of an Experimental Modal Analysis (EMA). Therefore, the measured data is transferred to the Standard Input Data (SID) format by means of the software MORPACK (Model Order Reduction PACKage). The novel approach yields several challenges for which adequate solutions are presented. The feasibility is demonstrated at the example of an U‐section. The accuracy in the higher frequency range can be increased, which is especially important for vibro‐acoustic simulations. (© 2017 Wiley‐VCH Verlag GmbH & Co. KGaA, Weinheim)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.