Chairside polishing of heat-cured acrylic resin: An SEM and EDA study

Abstract

Purpose. This study investigated the surfaces produced on 2 commonly used heat-cured acrylic resins by 2 chairside polishing systems compared to conventional lathe polishing. It used energy dispersive analysis (EDA) and scanning electron microscopy (SEM) to investigate the abrasive materials bonded in the silicone points that are marketed for chairside polishing of acrylic resin.Materials and Methods. Using the 3 polishing systems (conventional as control, Shofu acrylic polishing system [AcryPoint], and Kenda Queen silicone polisher), 3 operators polished specimens using a defined protocol. Specimens were subjected to SEM and confocal microscopy. EDA was undertaken on the silicone polishing points.Results. Conventional polishing produced the superior surface, followed by the surfaces produced by the Shofu system and then Kenda Queen. However, both chairside polishing systems produced smoother surfaces on acrylic resin than the surfaces produced by either steel or tungsten carbide burs. Both the Shofu acrylic polishing system and Kenda Queen silicone polisher contain beads of cerium, which is widely used in industry for polishing of glass.Conclusion. Silicone polishing points marketed for polishing of acrylic resin could be used to produce smooth surfaces that have been adjusted with burs where there is no access to a laboratory lathe.—Reprinted with permission of Quintessence Publishing. Purpose. This study investigated the surfaces produced on 2 commonly used heat-cured acrylic resins by 2 chairside polishing systems compared to conventional lathe polishing. It used energy dispersive analysis (EDA) and scanning electron microscopy (SEM) to investigate the abrasive materials bonded in the silicone points that are marketed for chairside polishing of acrylic resin. Materials and Methods. Using the 3 polishing systems (conventional as control, Shofu acrylic polishing system [AcryPoint], and Kenda Queen silicone polisher), 3 operators polished specimens using a defined protocol. Specimens were subjected to SEM and confocal microscopy. EDA was undertaken on the silicone polishing points. Results. Conventional polishing produced the superior surface, followed by the surfaces produced by the Shofu system and then Kenda Queen. However, both chairside polishing systems produced smoother surfaces on acrylic resin than the surfaces produced by either steel or tungsten carbide burs. Both the Shofu acrylic polishing system and Kenda Queen silicone polisher contain beads of cerium, which is widely used in industry for polishing of glass. Conclusion. Silicone polishing points marketed for polishing of acrylic resin could be used to produce smooth surfaces that have been adjusted with burs where there is no access to a laboratory lathe.—Reprinted with permission of Quintessence Publishing.