Abstract
In this study, a finite volume method is employed to investigate the performance of a novel parabolic trough solar collector with synthetic oil–Al2O3 nanofluid as the heat transfer fluid. An annular porous structure is installed inside the absorber tube to improve heat transfer. The effects of the simultaneous utilization of porous structure and nanoparticle addition on heat transfer, pressure drop, and thermal efficiency of the receiver are investigated for different values of Reynolds number, volume fraction of nanoparticle, inlet temperature and Darcy number of the porous region. The results show that as Reynolds number and volume fraction of nanoparticle increase, heat transfer coefficient, pressure drop, and thermal efficiency increase. However, the increases in inlet temperature lead to the decreases in heat transfer coefficient, pressure drop, and thermal efficiency. At Reynolds numbers higher than 30×104, simultaneous utilization of porous structure with Da = 0.3 and nanoparticles increases heat transfer coefficients nearly 7% and 20%, pressure drops up to 42.5% and 42%, thermal efficiencies up to 8% and 15%, overall efficiencies nearly 5% and 14%, and exergetic efficiencies by 7% and 15% for inlet temperature of 500 and 600 K, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.