CFD Optimization of Gas-Side Flow Channel Configuration Inside a High Temperature Bayonet Tube Heat Exchanger With Inner and Outer Fins

Abstract

In this paper, the gas-side fluid flow distribution inside a bayonet tube heat exchanger with inner and outer fins is numerically studied. The heat exchanger is designed based on the traditional bayonet tube heat exchanger, where compact continuous plain fins and wave-like fins are mounted on the outside and inside surfaces of outer tubes, respectively, to enhance the heat transfer performance. However, gross flow maldistribution and large vortices are observed in the gas-side flow channel of baseline design. In order to improve the flow uniformity, three modified designs are proposed. Three vertical plates and two inclined plates are mounted on the inlet manifold for Model B. For the Model C, another six bending plates are mounted on the middle manifolds and three pairs of them are connected together. The Model D has a similar structure as Model C except for the two additional baffles. The results indicate that the flow distributions of Model C and D are much more uniform under different inlet Reynolds number, especially in the high inlet Reynolds number. Although the flow distribution of Model D is the best, its pressure drop is 2.6 times higher than that of Model C. Therefore, the design of Model C is the most optimized structure. Compared with the original design, the nonuniformity of Model C can be reduced by 42% while the pressure drop is almost the same under the baseline condition.