CFD analysis of thermal–hydraulic behavior of supercritical water in sub-channels

Abstract

Investigations on the thermal–hydraulic behavior in the supercritical water-cooled reactor (SCWR) fuel assembly have obtained a significant attention in the international SCWR community. However, there is still a lack of understanding and ability to predict the heat transfer behavior of supercritical fluids. In this paper, computational fluid dynamics (CFD) analysis is carried out to study the thermal–hydraulic behavior of supercritical water flows in sub-channels of a typical SCWR fuel assembly using commercial CFD code CFX-5.6. Three types of sub-channels, e.g. regular sub-channel, wall sub-channel and corner sub-channel, are analyzed. Effects of various parameters, such as boundary conditions and pitch-to-diameter ratios, on the mixing phenomenon in sub-channels and heat transfer are investigated. The turbulent mixing in tight lattice ( P/ D = 1.1) is lower than that in wide lattice ( P/ D > 1.1), whereas, the effect of pitch-to-diameter ratio on the turbulent mixing is slight at P/ D > 1.1. The amplitude of turbulent mixing in wall sub-channel is slightly higher than that in regular sub-channel and is close to that in corner sub-channel. The mixing coefficient in the sub-channel at P/ D ≥ 1.2 is in the range from 0.022 to 0.028. The results also show unusual behavior of turbulent mixing in the vicinity of the pseudo-critical point, and further investigation is needed. The mass mixing due to cross flow in wall sub-channel is much stronger than that in regular sub-channel at a same pitch-to-diameter ratio. The mass mixing in wall and regular sub-channels, especially at small pitch-to-diameter ratio, brings an unfavorable feedback to the heat transfer and strengthens the non-uniformity of the circumferential distribution of heat transfer. The strong mass mixing in corner sub-channel should be paid attention.