Abstract
This paper focuses on the issue of flow measurement in automotive heat exchangers. The measurement is complicated due to the limited space in the heat exchanger area and the non-uniform velocity profile. Therefore, only some measuring techniques can be used, which must be adapted to the specific conditions. The paper presents the initial stages of the development of a sensor for measuring the flow in a heat exchanger. These are CFD simulations used to determine the nature of the flow around the sensor and verify its effect on the flow field in its surrounding and on the entire heat exchanger. The results of these initial simulations are presented and discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.