Abstract
OBJECTIVE Anterior cervical discectomy and fusion (ACDF) is one of the most commonly performed spine procedures. It can be used to correct cervical kyphotic deformity, which is the most common cervical deformity, and is often performed using lordotic interbody devices. Worsening of the cervical sagittal parameters is associated with decreased health-related quality of life. The study hypothesis is that through the use of machined lordotic allografts in ACDF, segmental and overall cervical lordosis can be maintained or increased, which will have a positive impact on overall cervical sagittal alignment. METHODS Seventy-four cases of 1-level ACDF (ACDF1) and 2-level ACDF (ACDF2) (40 ACDF1 and 34 ACDF2 procedures) were retrospectively reviewed. Upright neutral lateral radiographs were assessed preoperatively and at 6 weeks and 1 year postoperatively. The measured radiographic parameters included focal lordosis, disc height, C2-7 lordosis, C1-7 lordosis, T-1 slope, and C2-7 sagittal vertical axis. Correlation coefficients were calculated to determine the relationships between these radiographic measurements. RESULTS The mean values were as follows: preoperative focal lordosis was 0.574°, disc height was 4.48 mm, C2-7 lordosis was 9.66°, C1-7 lordosis was 42.5°, cervical sagittal vertebral axis (SVA) was 26.9 mm, and the T-1 slope was 33.2°. Cervical segmental lordosis significantly increased by 6.31° at 6 weeks and 6.45° at 1 year. C2-7 lordosis significantly improved by 1 year with a mean improvement of 3.46°. There was a significant positive correlation between the improvement in segmental lordosis and overall cervical lordosis. Overall cervical lordosis was significantly negatively correlated with cervical SVA. Improved segmental lordosis was not correlated with cervical SVA in ACDF1 patients but was significantly negatively correlated in ACDF2 patients. There was also a significant positive correlation between the T-1 slope and cervical SVA. CONCLUSIONS In the study population, the improvement of focal lordosis was significantly correlated with an improvement in overall lordosis (C1-7 and C2-7), and overall lordosis as measured by the C2-7 Cobb angle was significantly negatively correlated with cervical SVA. Using lordotic cervical allografts, we successfully created and maintained significant improvement in cervical segmental lordosis at the 6-week and 1-year time points with values of 6.31° and 6.45°, respectively. ACDF is able to achieve statistically significant improvement in C2-7 cervical lordosis by the 1-year followup, with a mean improvement of 3.46°. Increasing the number of levels operated on resulted in improved cervical sagittal parameters. This establishes a baseline for further examination into the ability of multilevel ACDF to achieve cervical deformity correction through the intervertebral correction of lordosis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.