Abstract
In this paper, a comparative study between two techniques to determine material toughness through edge chipping measurements, is presented. The first technique relies on static Rockwell indentations, performed at well-defined distances from the edge with an increasing load until chipping occurs. The second technique keeps the applied load constant but drives the Rockwell indenter towards the edge at constant speed until a chip is formed (scratch testing). In most studied cases, our experimental results on ceramics are shown to conform with the predictions of previous models in the literature expressing the toughness K Ic as a function of chip size l c and critical chipping load P through K I c ≅ P / l c 3 / 2 . However, for silicon carbide, the toughness values obtained by both variants of the method are mutually incompatible. The discrepancy is shown to be related to the tangential loading occurring during scratch testing. A new equation for toughness assessment is derived that takes into account the influence of friction. This equation is demonstrated to match well the experimental results both for static and sliding indentation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
