Cementation in cold-water bryozoan sand, Tasmania, Australia

Abstract

Cold-water (<3–11°C) carbonate is the predominant sediment on the Tasmanian shelf. Calcitic skeletal grains (bryozoa, foraminifera, echinoderms, etc.) predominate over aragonitic (gastropods, etc.) ones. Non-skeletal grains are mostly micritic intraclasts with some pellets. Fibrous spherulitic and rhombohedral calcite submarine cements range up to 90% in the bryozoan sand. X-ray analyses show that the bryozoan sand is characterized by a spectrum of calcites (low to high magnesian) and some aragonite. A uniform spread of Mg concentrations from 0.06 to 2.48 wt.% indicates <3–10°C ambient water temperatures. The Mn (10–360 ppm) and Fe (176–2499 ppm) concentrations increase with increasing Mg values due to the formation of impure CaCO 3 phases. The Sr content in bryozoan sand (bryozoa = ∼ 3200 ppm Sr) decreases with increasing rhombohedral calcite cement, as low Mg-calcite precipitating from 3° C sea water would have 1350 ppm Sr. The bryozoan sand grains with fibrous spherulitic calcite cements have high Sr concentrations (4470–7000 ppm), in the same range as in aragonitic (detected only by X-ray analyses) bryozoan sand grains. The spherulitic calcite cements are either pseudomorphs after original aragonite cements or these calcite cements and aragonite were inverted from fibrous spherulitic vaterite, a predominant CaCO 3 polymorph at temperatures <10°C.