Cellulose hydrolysis catalyzed by highly acidic lignin-derived carbonaceous catalyst synthesized via hydrothermal carbonization

Abstract

Acidic carbonaceous solids were synthesized from mass pine alkali lignin via hydrothermal carbonization followed by sulfonation. Hydrothermal carbonization of lignin in the presence of acrylic acid (LAHC-SO3H) provided many more carboxylic groups than that in the absence of acrylic acid, allowing subsequent sulfonation to produce a highly active and stable catalyst for cellulose hydrolysis in the [BMIM]Cl-H2O solvent system. The hydrochar and catalyst were characterized using field emission scanning electron microscopy, X-ray diffractometer, X-ray photoelectron spectroscopy, thermal gravimetric analysis, Fourier transform infrared spectrometer, Brunauer–Emmett–Teller and acid–base titration. Results showed that a high acid content of 5.48 mmol/g, including carboxylic group (2.85 mmol/g), phenolic hydroxyl group (1.05 mmol/g) and sulfonic acid group (1.58 mmol/g), contributed significantly to the highly efficient hydrolysis of cellulose. Further, it was found that addition of trace water in [BMIM]Cl was favorable to cellulose hydrolysis. The highest yield (75.4%) of total reducing sugar (TRS) obtained in [BMIM]Cl-H2O at a mass ratio of 100:1 was more than twice that (36.1%) achieved in [BMIM]Cl without water; the corresponding reaction conditions were 50 mg of microcrystalline cellulose, 30 mg of catalyst, 1.0 g of [BMIM]Cl, 10 mg of H2O, reaction temperature of 130 °C and reaction time of 2 h. Furthermore, the TRS yield with 5 cycles for LAHC-SO3H was higher than 68.1%, and the catalytic activity of catalyst could be fully recovered (74.0% of TRS yield) easily by regeneration.