Abstract
AbstractA series of crosslinked polypropylene samples with increased melt strengths were prepared via a copolymerization reaction, followed by melt processing. These crosslinked PP samples (PP‐Cs) were foamed by a temperature rising process using supercritical CO2 as the physical blowing agent. The introduction of crosslinking structure resulted in PP‐Cs foams with well‐defined closed cell structure, decreased cell size, and increased cell density in comparison with a linear PP, which were attributed to the suppressed cell coalescence due to the significant increase in melt strength of PP‐Cs. Further increasing the crosslinking degree tended to enhance the suppression effect on the cell coalescence, and hence increase the cell density of PP foams under the same foaming conditions, especially at the longer foaming times. The well‐defined closed cell structure was observed at the foaming temperature of 170–250°C and saturation pressure of 12–20 MPa. POLYM. ENG. SCI., 2008. © 2008 Society of Plastics Engineers
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
