Abstract
Despite intensive research in optically stimulated luminescence (OSL) dosimetry, the number of materials with suitable properties for practical application remains limited. Among these, magnesium tetraborate (MgB4O7) has attracted attention as a potential host because of its effective atomic number, similar to those of water and living tissues, and the possibility of producing neutron-sensitive material by controlling the content of the 10B isotope. Specifically, Ce-doped MgB4O7 has been proposed as a promising OSL material for 2D dosimetry because of its rapid luminescence. While the literature on polycrystalline sintered MgB4O7:Ce is extensive, the objective of this work is to produce this material in glass-ceramic form, offering many advantages such as excellent formability into complex shapes, rapid mass production, easily controlled microstructure, and higher density (zero porosity) compared to conventional powder-sintered materials, potentially leading to dosimetric improvements. This paper describes the synthesis route and the effects of various thermal treatments of magnesium borate glass and the resulting glass-ceramics, along with their fundamental dosimetric properties. The samples heat-treated at 814 °C for 3 h (GC814) exhibited the most intense and stable thermoluminescence peaks, accounting for their lowest signal fading among the investigated treatment conditions. However, during the OSL readout, diminished intensity was observed. Analysis of the GC814 emission spectrum revealed TL peaks predominantly outside the used optical filter's primary transmittance range, likely contributing to the OSL signal reduction. Regardless of the thermal-treatment condition, all the samples presented excellent repeatability of the OSL response, with standard deviations ranging from 0.1 % to 0.7 %, underscoring the advantages of glass-ceramics over sintered ceramics. From step-annealing analysis, an optimal preheat treatment temperature was identified, and the activation energy of the three main peaks was determined. The encouraging results indicate the potential of this glass-ceramic as a practical OSL dosimeter and justify further investigation to optimize its OSL properties.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.