Cavitation erosion performance and phase transformation strengthening behavior of laser clad iron-based shape memory alloy coatings

Abstract

In order to avoid cavitation damage on the surface of overcurrent components after long-term service, the surface is reinforced with a coating to improve its cavitation resistance, thus prolonging service life. The present study employed analytical techniques, such as X-ray diffractometry (XRD), scanning electron microscopy (SEM), electron backscatter diffraction (EBSD), and transmission electron microscopy (TEM), to investigate the cavitation erosion performance of laser clad Fe-Mn-Si-Cr-Ni shape memory alloy (SMA) coatings with focus on the enhancing mechanism of their martensitic phase transformation. The results indicated that laser cladding could produce high-quality SMA coatings, free of defects such as pores and cracks, resulting in a significant improvement in the cavitation erosion performance. After 5 h of the cavitation, the coated samples remained in the cavitation erosion incubation stage, demonstrating an accumulated mass loss rate of approximately 0.12 mg/h, merely 13 % of that observed in the matrix samples. Extensive microstructural delamination occurred in the matrix samples after 5 h of the cavitation, whereas the coated samples exhibited only "shear bands" formed by plastic deformation on the surface. The martensitic phase transformation from γ-austenite to ε-martensite served to dissipate the stress induced by cavitation bubble collapse on one hand, and, on the other hand, the robust nature of martensite produced a hardening effect, significantly enhancing the cavitation resistance of the coating.