Abstract
CrNi-alloys with high Cr-content generally are quite brittle and, therefore, only available as castings and regarded as neither weldable nor deformable. The process of friction surfacing offers a possibility to generate Cr60Ni40 coatings e.g. on steel or Ni-base substrates. Cavitation tests were carried out using an ultrasonic vibratory test rig (∼ASTM G32) with cast specimens and friction surfaced coatings. The coatings show less deformation and smaller disruptions, and wear rates in steady state were found to be three times higher for the cast and heat treated samples than for the coatings, caused by a highly wear resistant Cr-rich phase. The results of this study show that it is possible to generate defect free coatings of Cr60Ni40 with a thickness of about 250μm by friction surfacing, which under cavitation show a better wear behavior than the cast material. Thus, in combination with a ductile substrate, these coatings are likely to extend the range of applicability of such high-temperature corrosion resistant alloys.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
