Abstract
Causes of formation of defects on the internal surface of oil tubes with ends formed by upsetting in SMS Meer hydraulic presses are considered. Interrelated requirements on billets and calibration of the equipment aimed at intensifying the upsetting process in one pass with growth of the wall thickening factor to about 1.85 are formulated.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
