Abstract
During diagenesis of Jurassic and Cambrian oil source rock shales illite-smectite(-vermiculite) [I-S(-V)] is transformed to illite-tobelite-smectite(-vermiculite) [I-T-S(-V)]. This transformation of S layers to T layers takes place by an increase in tetrahedral charge through Al for Si substitution and subsequent fixation of interlayer NH 4 , accompanied by an increase in Al and a decrease in Fe and Mg in the octahedral sheet. In the present investigation, the distribution of isomorphous cations in octahedral sheets of trans-vacant I-S(-V) and I-T-S(-V) was studied by Mössbauer and Infrared (IR) spectroscopies. Mössbauer spectra have been modeled using numerical values of the Fe 3+ and Fe 2+ quadrupole doublets corresponding to local cation arrangements around Fe 3+ and Fe 2+ in octahedral sheets of micaceous minerals. To interpret IR spectra in the OH-stretching region, frequencies for each pair of cations bonded to OH groups determined for micas and I-S are used. Combination of Mössbauer and IR data by computer simulation provides two-dimensional cation distributions of octahedral cations. The Jurassic and Cambrian I-S(-V) and I-T-S(-V) have clustered octahedral sheets. Ordered clusters of mixed cation composition (Mg, Al, Fe 3+ , and Fe 2+ ) with regular alternation of di- and trivalent cations and Fe 3+ -clusters dispersed over an Al-matrix are found in detrital samples. In diagenetically transformed samples, ordered clusters persist while Fe 3+ -clusters degenerate to either short chains consisting of two Fe-Fe pairs or to isolated Fe-Fe pairs oriented along the b, b 1 , and b 2 directions. The release of Fe and Mg during diagenesis occurs from Fe 3+ clusters and through partial destruction of ordered clusters and of b 1 , b 2 -oriented Mg-Mg pairs. However, as the cation composition and the short-range cation order within the clusters are preserved and the Al for Fe and Mg substitution occurs at cluster edges, the diagenetic transformation of S (and V) to T layers in both the Jurassic and Cambrian I-S(-V) proceeds through a solid-phase transformation and not through dissolution-reprecipitation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.