Abstract

Abstract. Of the various approaches for estimating groundwater recharge, the chloride mass balance (CMB) method is one of the most frequently used, especially for arid and semiarid regions. Widespread native vegetation clearance, common in many areas globally, has changed the land surface boundary condition, posing the question as to whether the current system has reached new chloride equilibrium, required for a CMB application. Although a one-dimensional CMB can be applied at a point where the water and chloride fluxes are locally in steady state, the CMB method is usually applied at a catchment scale owing to significant lateral flows in mountains. The applicability of the CMB method to several conceptual catchment types of various chloride equilibrium conditions is examined. The conceptualisation, combined with some local climate conditions, is shown to be useful in assessing whether or not a catchment has reached new chloride equilibrium. The six conceptual catchment types are tested with eleven selected catchments in the Mount Lofty Ranges (MLR), a coastal hilly area in South Australia having experienced widespread historical forest clearance. The results show that six of the eleven catchments match a type VI chloride balance condition (chloride non-equilibrium with a gaining stream), with the ratios of stream chloride output (O) over atmospheric chloride input (I), or catchment chloride O/I ratios, ranging from 2 to 4. Two catchments match a type V chloride balance condition (chloride non-equilibrium with a losing stream), with catchment chloride O/I ratios about 0.5. For these type V and type VI catchments, the CMB method is not applicable. The results also suggest that neither a chloride O/I ratio less than one nor a low seasonal fluctuation of streamflow chloride concentration (a factor below 4) guarantees a chloride equilibrium condition in the study area. A large chloride O/I value (above one) and a large fluctuation of streamflow chloride concentration (a factor of 10 and above) generally indicates either a chloride disequilibrium, or cross-catchment water transfer, or both, for which the CMB method is not applicable. Based on regression between chloride O/I values and annual precipitation for type VI catchments, a catchment with annual precipitation of 900 mm in MLR has most likely reached new chloride equilibrium, and the CMB method can be applied if no cross-catchment water transfer occurs. CMB is applied to one catchment at chloride equilibrium, suggesting a net groundwater recharge of 27 mm/yr, about 3% of annual precipitation.

Highlights

  • Among the various approaches for estimating groundwater recharge, the chloride mass balance (CMB) method is one of the most frequently used, especially for arid and semiarid regions (Petheram et al, 2002; Scanlon et al, 2002; Wilson and Guan, 2004)

  • The primary objectives of this study are (1) to conceptualize catchment chloride equilibrium conditions and their quantitative indicators, (2) to demonstrate how these conceptual models, combined with climate information, are useful in assessing whether a catchment has reached a new chloride equilibrium for the CMB application, (3) to identify catchments in a coastal hilly region of South Australia that are valid for CMB application, and (4) estimate catchment groundwater recharge for these catchments

  • The abnormally high chloride O/I ratio indicates a chloride disequilibrium condition, a conclusion supported by large fluctuations of stream water chloride concentrations which range from below 200 mg l−1 during the event flow to about 4000 mg l−1 at the beginning of rainy seasons

Read more

Summary

Introduction

Among the various approaches for estimating groundwater recharge, the chloride mass balance (CMB) method is one of the most frequently used, especially for arid and semiarid regions (Petheram et al, 2002; Scanlon et al, 2002; Wilson and Guan, 2004). The basic idea of the CMB method is that the atmospheric input of chloride in precipitation as well as dry deposition is concentrated in the residual soil water via evapotranspiration (ET) processes. By measuring chloride concentration in soil water, or the resulting groundwater, we can estimate the (potential, if soil chloride is used) recharge rate. H. Guan et al.: Catchment conceptualisation for examining applicability of chloride mass balance method

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call