Catalytic Decomposition of H2O2over Pure and Li2O-Doped Co3O4Solids

Abstract

Pure and doped Co3O4samples were prepared by the thermal decomposition at 500–900°C of pure and lithium nitrate-treated basic cobalt carbonate. The amounts of dopant added were varied in the range 0.75–6 mol% Li2O. The effects of this treatment on the surface and catalytic properties of cobaltic oxide solid were investigated using nitrogen adsorption at −196°C and studies of the decomposition of H2O2at 30–50°C.The results obtained revealed that Li2O doping of Co3O4followed by heat treatment at 500°C and 600°C resulted in a progressive increase in the value of the specific surface area, SBET, to an extent proportional to the amount of dopant present. However, the increase was more pronounced in the case of solid samples calcined at 500°C. This increase in the specific surface areas has been attributed to the fixation of a portion of the dopant ions on the uppermost surface layers of the solid leading to outward growth of the surface lattice. The observed increase in SBETdue to Li2O doping at 500°C might also result from a narrowing of the pores in the treated solid as a result of the doping process. Lithium oxide doping of cobaltic oxide followed by heat treatment at 700–900°C resulted in a significant decrease in the SBET, Vpand r̄ values. Pure and doped solids precalcined at 500°C and 600°C exhibited extremely high catalytic activities which were not much affected by doping with Li2O. On the other hand, doping followed by calcination at 700–900°C brought about a considerable and progressive increase in the catalytic activity of the treated solids. This treatment did not modify the activation energy of the catalysed reaction, i.e. doping of Co3O4solid followed by heating at 700°C and 900°C did not alter the mechanism of the catalytic reaction but increased the concentration of catalytically active constituents taking part in the catalytic process without altering their energetic nature.