Abstract

A recently developed forcing scheme has allowed the pseudopotential multiphase lattice Boltzmann method to correctly reproduce coexistence curves, while expanding its range to lower surface tensions and arbitrarily high density ratios [Lycett-Brown and Luo, Phys. Rev. E 91, 023305 (2015)PLEEE81539-375510.1103/PhysRevE.91.023305]. Here, a third-order Chapman-Enskog analysis is used to extend this result from the single-relaxation-time collision operator, to a multiple-relaxation-time cascaded collision operator, whose additional relaxation rates allow a significant increase in stability. Numerical results confirm that the proposed scheme enables almost independent control of density ratio, surface tension, interface width, viscosity, and the additional relaxation rates of the cascaded collision operator. This allows simulation of large density ratio flows at simultaneously high Reynolds and Weber numbers, which is demonstrated through binary collisions of water droplets in air (with density ratio up to 1000, Reynolds number 6200 and Weber number 440). This model represents a significant improvement in multiphase flow simulation by the pseudopotential lattice Boltzmann method in which real-world parameters are finally achievable.

Highlights

  • The lattice Boltzmann method (LBM) is a mesoscopic simulation approach that provides an attractive alternative to traditional computational fluid dynamics

  • We have shown that the surface tension parameter, σc, can be varied with only slight effects on the gas density, and that with the newly introduced correction accounting for the cascaded collision operator, this result is unaffected by varying the associated additional relaxation rates

  • While the results presented here are a significant advance for the pseudopotential multiphase LBM, it should be noted that other methods such as that by Lee and Fischer [42] have successfully reduced spurious velocities for comparable interface widths and density ratios

Read more

Summary

INTRODUCTION

The lattice Boltzmann method (LBM) is a mesoscopic simulation approach that provides an attractive alternative to traditional computational fluid dynamics. The method of Guo et al [17] performs better than the EDM for the exponential form of the equation of state proposed by Shan and Chen This had previously resulted in some confusion over which forcing scheme is the most appropriate to use. Lycett-Brown et al [19,33] provided an alternative derivation of the cascaded LBM and extended it to a pseudopotential multiphase scheme, resulting in increased stability at low viscosity, and the reduction of spurious velocities by tuning the relaxation rates of the higher-order moments.

THE CASCADED LATTICE BOLTZMANN METHOD
THIRD-ORDER CHAPMAN-ENSKOG EXPANSION
RESULTS
Coexistence curve
Surface tension
Relaxation rates
Interface width
Sound speeds
BINARY DROPLET COLLISIONS
CONCLUSION

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.