Carbon molecular sieve electrodes with intrinsic microporosity for efficient capacitive deionization

Abstract

Capacitive deionization (CDI), apromisingprocessfor desalinatinglow-salinity water, is currently characterized by the prevalent use of activated carbon (AC) electrodes that exhibit somewhat suboptimal performance. One potential method for increasing the electrosorption capacity of an electrode involves boosting its porosity and conductivity by using conductive polymers or applying heat treatment to porous polymers. This study examines the performance of the capacitive deionization (CDI) process using a range of highly porous carbon molecular sieve (CMS) electrodes. These electrodes are derived from intrinsically microporous polyimide 4,4′-(hexa-fluoroisopropylidene) diphthalic-anhydride (6FDA)-3,3′ dimethyl-naphthidine (DMN) (6FDA-DMN) and prepared at temperatures of 600, 800, and 1000 °C. The electrodes that were produced exhibited a high Brunauer-Emmett-Teller (BET) surface area ranging from 574 to 729 m2g−1. Additionally, they displayed a symmetric cyclic voltammetry (CV) plot with a specific capacitance ranging from 17.75 to 67.91 Fg−1 at a scan rate of 5 mVs−1. The charge transfer resistance (Rct) values for the 6FDA-DMN-based CMS P1, P2, and P3 electrodes were measured to be 9.7 Ω, 1.2 Ω, and 0.9 Ω, respectively, in a 1 M NaCl solution. The CMS electrode, synthesized at a temperature of 800 °C (P2), exhibits exceptional electrosorption capabilities in a saline solution with a concentration of 600 mgL−1. It displays a remarkable capacity of 36.9 mgg−1 and a rate of 2 mgg−1min−1, surpassing the performance of activated carbons (ACs). This research establishes a pathway for optimizing the characteristics and performance of electrodes by thermal treatment. This research demonstrates for the first time the effect of thermal annealing on the CDI performance of CMS materials, which will aid in developing electrode materials for large-scale water desalination.