Abstract
Electric vehicle (EV) batteries require both thermal regulation and crash protection. A novel battery packaging scheme is presented that uses microvascular composite panels with 2D channel networks to accomplish both objectives. Microvascular carbon fiber/epoxy composite panels are fabricated by vacuum assisted resin transfer molding, with the channel network formed by post-cure vaporization of an embedded polylactide channel template. Panel cooling performance is evaluated for parallel, bifurcating, serpentine, and spiral channel designs at different coolant flow rates and channel diameter. The spiral design provides the best thermal performance, but requires high pumping pressure (>100kPa) at the flow rates needed for adequate cooling (>30mLmin−1). The bifurcating design and a network obtained by computational optimization offer much lower pressure with slightly reduced thermal performance. Channel diameter has negligible effect on cooling performance, but strongly affects pumping pressure. Computational fluid dynamics (CFD) simulations are also performed and correlate well with the experimental data. Simulations confirm that microvascular composite panels can cool typical battery cells generating 500Wm−2 heat flux below the target temperature of 40°C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.