Abstract
The capillary module (CM), consisting of parallel capillaries from terminal arteriole to post-capillary venule, is classically considered to be the building block of complex capillary networks. In skeletal muscle, CMs form interconnected columns spanning thousands of microns, which we recently described as the capillary fascicle. However, detailed evaluation of CM haemodynamics has not been described, and may provide insight into mechanisms of blood flow regulation in the microcirculation. We used intravital videomicroscopy from resting extensor digitorum longus muscle in rats (n=9 networks, 112 capillary modules), as well as dual-phase computational modelling of blood flow in simulated CM geometries. We found that the mean driving pressure across CMs was 3.236±1.833mmHg. Red blood cell (RBC) flow was independent of CM resistance, and the ratio of blood flow in adjacent modules was not correlated with their ratio of resistances. In simulated CM geometries, increases to driving pressure produced a direct linear increase to RBC and plasma flow, with no changes to RBC distribution; increases to arteriolar inflow haematocrit resulted in increased RBC flow, but with viscosity-dependent increases to CM resistance. CM RBC flow heterogeneity was higher than plasma flow heterogeneity in experimental data, in contrast to simulated geometries, suggesting that time-dependent flow variability may have important consequences for RBC distribution. In summary, these findings suggest that CMs are active participants in microvascular flow regulation, likely achieved through adjustments to CM driving pressure using pre- and post-capillary loci of flow control. Increases to CM viscosity may be important during the regulation of functional hyperaemia. KEY POINTS: The capillary module (CM), consisting of parallel capillaries from the arteriole to venule, is classically considered to be the building block of capillary networks in skeletal muscle. A detailed evaluation of module haemodynamics may provide insight into mechanisms of blood flow regulation in the microcirculation. Using experimental data from resting skeletal muscle in rats, as well as dual-phase computational models of blood flow, we analysed haemodynamic relationships and the impact of variations to boundary conditions on red blood cell and plasma distribution. We showed that driving pressure across CMs is low, and that simulated increases to inflow haematocrit have important viscosity-dependent effects on module resistance. We found that red blood cell flow was independent from module resistance, which strongly suggests the regulation of driving pressure at the level of the capillary module using pre- and post-capillary loci of flow control. These findings place CMs as central participants in microvascular flow regulation, with important consequences for disease and functional hyperaemia.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.