Abstract
Moisture content of wood chips is an important factor to be known in their utilization as a biomass material. Several moisture measuring instruments are available in the market, but for most of these instruments, some sort of sample preparation is needed that involves sizing, grinding, and weighing. The samples in this process are usually destroyed, and the measurement involves considerable time and labor. The standard methods of oven drying and Karl Fisher also fall in the destructive and laborious category. In this paper, estimation of moisture content of hardwood chips, from the measurement of certain electrical properties of a parallel-plate capacitor, holding the samples of these materials between them at two radio frequencies, is presented. The wood chip samples tested were in the moisture range of 3%–50%. The standard error of prediction was 2.0, and the prediction accuracies were better for the samples with moisture contents below 25%. The construction and performance of a prototype moisture sensing instrument working on these principles is briefly described. This method being nondestructive and rapid would be useful in the biofuel industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
