Camel milk whey powder formulated using thermal (spray-drying process) and non-thermal (ultrasonication) processing methods: Effect on physicochemical, technological, and functional properties

Abstract

Whey protein concentrates (WPCs) are gaining importance as a functional ingredient due to their high technological and functional properties. In this study, Camel milk whey (CW) separated from skimmed camel milk, then either spray-dried (SD) at 170, 185 and 200 °C, or treated by ultrasonication (US) (20 kHz (for 5, 10 and 15 min followed by freeze-drying to obtain camel milk whey powder (CWP). The structural analysis of CWP was carried out by Fourier-Transform Infrared Spectroscopy (FTIR) and X-Ray Diffraction (XRD) which showed no significant difference in the functional groups profile of US samples compared to control and SD samples. US samples showed some degree of crystallinity that was comparable to the control samples, while SD samples exhibited very low degree of crystallinity. The surface morphology, particle size, and surface charge of CWP were evaluated using scanning electron microscopy (SEM) and Zetasizer. The lowest particle size of 215.1 nm with surface charge of −21.6 mv was observed in SD-185 WPC. Moreover, SD samples revealed whiter color compared to the US-treated samples which were having lower L* values (P < 0.05). US-15 sample exhibited high protein solubility (100 %), whereas the SD-200 sample showed reduced solubility (92.7 %). Improvement in the emulsifying activity of CWP samples was observed after SD and US, with highest emulsifying activity index (EAI) values of 143.75 m2/g and 143.11 m2/g were reported for SD-185 and US-15 CWP samples, respectively. To conclude, SD and US were found to improve the physico-chemical, technological, and functional properties of CWP, and thus can be utilized as a promising strategy to preserve and enhance techno-functional properties of CWP