Abstract

The calibration of the model is one of the most important steps in the development of models of engineering systems. A new approach is presented in this study to calibrate a complex multi-domain system. This approach respects the real characteristics of the circuit, the accuracy of the results, and minimizes the cost of the experimental phase. This paper proposes a complete method, the Global Optimization Method for Parameter Calibration (GOMPC). This method uses an optimization technique coupled with the simulated model on simulation software. In this paper, two optimization techniques, the Genetic Algorithm (GA) and the two-level Genetic Algorithm, are applied and then compared on two case studies: a theoretical and a real hydro-electromechanical circuit. In order to optimize the number of measured outputs, a sensitivity analysis is used to identify the objective function (OBJ) of the two studied optimization techniques. Finally, results concluded that applying GOMPC by combining the two-level GA with the simulated model was an efficient solution as it proves its accuracy and efficiency with less computation time. It is believed that this approach is able to converge to the expected results and to find the system's unknown parameters faster and with more accuracy than GA.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.