Abstract
In this study, 3D scanning systems that utilize a pair of laser stripes are studied. Three types of scanning systems are implemented to scan environments, rough surfaces of near planar objects and small 3D objects. These scanners make use of double laser stripes to minimize the undesired effect of occlusions. Calibration of these scanning systems is crucially important for the alignment of 3D points which are reconstructed from different stripes. In this paper, the main focus is on the calibration problem, following a treatment on the pre-processing of stripe projections using dynamic programming and localization of 2D image points with sub-pixel accuracy. The 3D points corresponding to laser stripes are used in an optimization procedure that imposes geometrical constraints such as coplanarities and orthogonalities. It is shown that, calibration procedure proposed here, significantly improves the alignment of 3D points scanned using two laser stripes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
