Abstract
An on-board device for bolting to the axlebox of a railway vehicle or locomotive to measure rolling noise close to the wheel surface has been developed by the authors (1, 2). Even though laboratory calibration and test runs have shown that the measured noise data are consistent, there was no way to prove that they were in accordance with the on-ground measured ones. Italian State Railways (FS) have performed tests with different wheelsets to evaluate the efficiency of several noise-reduction solutions; during these tests it was possible to repeat noise measurements on-board, therefore obtaining a sufficient amount of data to calibrate the device and to analyse in detail the behaviour of such wheelsets. Calculated calibration constants prove that on-board measured data can be used with confidence to estimate noise levels at several distances from the track, thereby reducing the necessity of long and expensive on-ground tests to measure environmental noise pollution.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
